Second-hand housing decoration six difficulties in advance psychological preparation

There is a small group of people who do not understand the truth and say that the second-hand house decoration should be easier than the renovation of a new house. After all, it is just a change on the original basis. When these people eat the melons in their hands, they will understand that the second-hand house decoration is not as simple as it should be, and even some links are more complicated than the new ones. Here's a brief introduction to the difficulties of second-hand house decoration and be prepared in advance.

Difficulties in the renovation of second-hand housing

The old galvanized pipe + the old valve is still not able to hold water, which is not easy to use and it is inconvenient to use, and it has to be replaced completely. Solution: For the old iron pipe water supply, remove the original pipe and confirm the new shower in the kitchen. , washbasins, toilets, washing machines, wash basins. The location of the water supply. Need to give greetings to the property company or neighborhood committee in advance, and explain to the neighbors in the same building the reasons for stopping the water for a moment. Under normal circumstances, everyone will understand and then have to replace the main valve between 9:30 am and 4:00 am to avoid Open meals and other water peaks.

Second-hand housing renovation difficulties Second, the problem of strong electricity

The strong electric lighting and the socket share a common circuit. The wire is an aluminum core wire or a small-diameter copper core wire. Once several electric appliances are opened in the process of use, the main switch is quasi-jump and cannot be used normally. 2 At the end of the last century, the state had used a capacity-enhancement process for the second-hand housing power. Generally, the capacity expansion was limited to the air-conditioning circuit and it was basically guaranteed to be used. However, most of the capacity-added cable runs were trunking or direct sheathing. Outside the wall, the decorative appearance is seriously affected. 3 The old building's switchboard settings are generally old, and the power ratio is not reasonable and needs to be reset.

Solution: Due to the use of high-power electrical appliances in real life, far more than ten years ago, the power distribution system can withstand, air conditioning is generally single-channel settings, lighting single-way settings, ordinary outlet single-loop settings, kitchen bathroom outlets as needed to do a single loop setting . In addition to the total loop, the general old house is set to have a distribution circuit of 5 to 7 roads, which can basically meet the needs of the next decade.

Difficulties in the renovation of second-hand housing III. Leakage problems

The bathroom and kitchen waterproofing layer of the old house has been in disrepair for a long time, and the leakage prevention effect has been greatly reduced. If you ignore this piece during the renovation, in the future the owner will surely suffer from flooding and the mildew.

Solution: Close the water test for the toilet Before decorating the second-hand house, first of all, the decoration worker should be asked to close the water test for the restroom, and check how the previous waterproof treatment is done. The method is: block the floor drain, put 5 cm of water in the toilet, observe for 24 hours, and then go to the neighbor's house downstairs to check, if there is no leakage phenomenon, prove that the waterproof treatment is done well; if it leaks, you must ask the property to re-waterproof After processing, after the waterproof treatment, wait for the ground to completely dry and then tile again, otherwise the ground will crack.

Second-hand housing transformation difficulties four, switch socket

With more and more appliances used in homes, lighting and lighting equipment are becoming more and more colorful, so there are many places where switches and sockets need to be placed. Well, before the renovation, we must do a good job of wiring in advance, which places need to be placed in the future, to do a good job in advance planning, and the old house reserved switches and sockets are generally not enough. In general, a room should have at least 3 sockets. There should be no fewer than 15 sockets in a two-bedroom residential building and no less than 8 switches. The switch height of the same room should be the same, the general switch is 1.4 meters from the ground, and the outlet is 0.3 meters from the ground. The switch between the suspension and the living room should be set in a place easily accessible to the owner.

Second-hand housing renovation difficulties five, weak wiring

Telephones, televisions, and intercoms are all rewired outside the wall. All of them require rewiring. Solution: We will first ask the owners whether they need to use broadband in the future or install ADSL on their own, because the LAN wiring methods of these two Internet access methods are not exactly the same. Then determine where to place the router inside the home, Internet sharing problems to solve; For the old house water and electricity reform in the intercom system, the general property is not how to manage, and some even do not have a property company, need to operate in accordance with the norms of construction, to ensure sound or figure Like clarity.

Difficulties in the renovation of second-hand housing 6. Wall problems

The old house is like a woman of old age. No matter how heavy the wild goose is, how can the years appear on the smooth skin. The same is true of the walls of old houses. Cracking and cracking are common occurrences. However, if you do not perform the primary treatment, refresh the paint directly. It's like if you don’t solve a skin condition, you’ll have to stop the symptoms.

Solution: painting the wall is the key to the old wall of the old house will appear cracking, peeling phenomenon, so when the decoration of the wall, we must pay attention to do a good job at the grassroots level, generally good decoration company in the wall leveling After that, it will be coated with an interface agent, the interface agent will have a moisture-proof effect, and it can also play a role in protecting the latex paint. Next is the putty, the putty paste should be made of waterproof putty, the putty should be scraped three times, and finally the brush Latex paint. If the wall is to be colored, paint it accordingly.

Second-hand house decoration

Professional Bonded NdFeB Magnets manufacturer is located in China. CBNB Magnets could provide very high quality Bonded NdFeB Magnets at very competitive prices.

Bonded NdFeB Magnets

NdFeB Magnet, NdFeB Magnets, Bonded NdFeB Magnets, Super Strong Magnets

Ningbo Besten Magnet Co., Ltd. , http://www.cbnb-magnets.com