Planetary gear motors are getting worse and worse? Dalan Motor recommends you to improve from 4 aspects! Use of planetary gear motor

Planetary reducer has a very powerful anti-lock function, can produce a large reduction ratio, and has a strong practicality. In the process of use, we must pay attention to the lubrication and maintenance of the planetary reducer. So what should we pay attention to? Dalan Electric Editor made a summary for everyone.

1. Hammering is strictly forbidden, and the output shaft of the reducer is installed. Couplings, belt wheels, sprockets and other coupling parts cannot be directly hammered. The output shaft structure of the reducer cannot withstand axial hammering. Screw in the screw hole at the shaft end to press in the coupling piece.

2. Be sure to install a vent cap (exhaust screw plug). Before use, replace the blockage at the highest position with an exhaust screw plug to ensure that the gas is discharged from the reducer during operation. If it is not replaced in time, the reducer will run for a long time, and the gas in the reducer will swell the oil seal, and the reducer will leak oil.

3. Change the lubricating oil in time, pay special attention to the first time. Special attention should be paid to the first oil change. The lubricating gear should be replaced in time after 300 to 400 hours of the first operation, and every 1500 to 2000 hours thereafter lubricating oil. In addition, in the working environment with harsh working environment, high temperature and heavy dust, the lubricant should be inspected every half a month. If the lubricant is found to be dirty, replace the lubricant.

4. The planetary reducer must be lubricated with lubricating oil, so before it can work normally, a specific type and specification of grease must be installed inside the reducer. For a vertical reducer, the installed lubricating oil cannot effectively lubricate the upper parts, and other effective measures must be taken to lubricate it. The ambient temperature of the reducer when it is working cannot be greater than 80 degrees. The planetary gear stages of the reducer cannot exceed three stages.

----- Responsible Editor: Dalan Oil Pump Motor 02-Procurement Consultant

Copyright http: / (Dalan Motor) Reprint, please indicate the source

================================================== ================================================== ======

Stable Isotopes

Shandong Zhongshan Photoelectric Materials Co., Ltd ,