"When laying the floor, more than 20 pieces of boards were only cut a little bit and then thrown away, letting me dig a few hundred yuan in vain." Recently, the consumer, Ms. Zhang, told reporters that she complained that her family had encountered a problem in laying the floor. The irritated thing. After some investigations, a reporter from Jiuzheng Building Materials Network found that some floor vendors made workers deliberately increase floor losses in order to sell more goods; and the current labor cost for floor laying is calculated based on the floor area used. Some decoration workers are also willing to cooperate with the merchants. Spread two square meters more to make more money. Ms. Zhang said that when buying flooring at the time, the merchant indicated that she would pay more for less. In order to unify the color, it is recommended that Ms. Zhang buy more and relax the ratio by about 5%. According to the measurement, the floor area is 86 square meters. Ms. Zhang specially bought a 90 square meter floor for unexpected needs. However, what she did not expect was that when the laying was about to end, the workers asked her to buy two more square meters. The floor of the rice, because the board is not enough, but there are more than 20 boards on the ground with their heads or sides cut, thrown on the ground and scrapped. Ms. Zhang said that she was busy at work, so she trusted the workers and left them with the floor. But when she took the time to see the site, she found that the workers "lacked collaboration and cut the floor at will". Some of the remaining small boards can be used together Yes, it is necessary to cut the whole board. Ask the workers, they said that the floor interface should be aligned, so they need to cut new boards. After the paving was completed, Ms. Zhang made a careful calculation and was shocked: a total of 86 square meters of flooring was paved, 92 square meters were actually used, and the loss rate was 7%. The boards thrown away in vain are distressed. However, it is no longer useful. The floor of more than 300 square meters was spent by workers at least 3 square meters, and they spent nearly a thousand yuan in inadvertent money. Why is there a loss on the floor, what is the general loss rate? A reporter from Jiuzheng Building Materials Network interviewed the person in charge of Xinwu Flooring. According to reports, the length and width of each floor are the same in floor laying, but the length of the wooden board purchased by consumers cannot be exactly matched with the room to be laid. So some floors have to be cut, such as 90 cm long floors, if you use 50 cm, the remaining 40 cm will have to be stitched to other places, if you ca n’t splice it, you can only throw it away, which causes loss, as long as the room is compared Neat, the general loss rate is about 3%. According to the regulations, after consumers lay the floor, the complete floor can be returned. However, in order to prevent consumers from returning goods, some unscrupulous merchants will increase the consumption to make consumers spend more money, such as deliberately cutting more complete boards. There is also a more concealed method, some floors themselves have "short catty two" situation, such as the original should be 90 cm long board, but some products are only 85 cm, consumers often only count the number of floors when buying , I would n’t think of measuring the length and width of each floor, so the amount of floor actually used is secretly increased. The editor of Jiuzheng Building Materials Network specially consulted the experts of Chengdu Jiahan Material Company. The experts of Chengdu Jiahan Material Company said: In the past, floor disputes were mostly concentrated on the quality of the floor itself or the quality of the floor laying. This "malicious floor loss" The phenomenon also began to look up. In this regard, he reminded consumers to choose reputable merchants and brand floors when buying and paving floors, carefully measure before buying, and pay attention to the progress of paving in the process of paving to prevent pavers from doing tricks. According to the GBT20238-2006 "Code for Wooden Floor Pavement, Acceptance and Use" issued by the state, the loss rate of the pavement floor should generally not exceed 5%. Experts from Chengdu Jiahan Materials Company remind consumers that if the floor loss rate exceeds 5% , You can claim from the merchant.
1200 mm diameter Sieve Machine is a standard and popular size sieve machine. it is widely used in food, Pharmaceuticals, chemical, building materials, plastic, mining, environmental protection and other fields.
The Vibrating Screen is a high efficiency machine, which can fit 1 ~ 5 layers of sieves.
Vibrating Screen, 1200mm Sieve Machine, 1.2 meter stainless steel vibrating screen Xinxiang Xin Ming De Machinery Co., Ltd. , https://www.xmdsieve.com
Floor wear rate exceeds 5%, consumers can claim compensation from merchants